Goulds Pumps 3600 - IOM - Manual (Page 88)

Maintenance
h) When you have achieved the proper bearing assembly, set the lockwasher tab in the
slot in the locknut.
4. Install the bearing housing (134) over the bearings. Finger-tighten the nuts (427J) on the
studs (371T). Insert the dowel pins (469J); then tighten the nuts (427J).
The bearing housing is doweled to the casing (100) during the original build to assure the
correct running position of the shaft.
NOTICE:
The bearing housing flange must fit metal-to-metal (no gap) to the bearing saddle flange.
5. Tighten the inboard end-cover capscrews (317C).
6. Install the oil ring (114).
7. Install the bearing end cover (109A) and the bearing end-cover gasket (360A) with the end-
cover capscrews (371C).
8. When new bearings are installed, you must measure the axial end play:
a) Bolt the end cover to the thrust housing.
b) Move the shaft axially from the coupling end.
86 Model 3600, API 610 8th, 9th, 10th & 11th Editions (ISO 13709) Installation, Operation, and Maintenance Manual