Glastender GT-30 - Manual (Page 10)

Glastender, Inc. • 5400 North Michigan Road • Saginaw, MI • 48604-9780
800.748.0423 • 989.752.4275 • Fax 989.752.4444 • www.glastender.com
8
1. Place Top Section of glasswasher on the extreme rear of the Main Section (see Figure 1, page 3.).
Note: The Glass Stop Arm always identifies the front of the unit.
2. Remove front panel of Main Section (see Figure 1, page 3.).
3. Detergent and Sanitizer Feed Lines are stored in Main Section. Access is provided in the floor of the
front Main Section. Fully extend the Feed Lines to the Detergent and Sanitizer Containers which are
external of the unit. Shorten Feed Lines if necessary.
Note: Consult your chemical supplier for detergent and sanitizer products.
a. Use an extra-heavy-duty, non-foaming, commercial liquid dishwashing detergent.
b. Use liquid bleach (sodium hypochlorite - 5.25% solution) or low-sudsing iodine type sanitizer.
4. Remove Rinse Tank Guide.
5. Make sure the Fill Switch and Conveyor Switch are in the “off” position.
6. Open the hot water and cold water supply valves.
7. Turn electrical power “on.” Green Power Light will now be illuminated.
8. Turn Fill Switch to “on” position. The Wash Tank will fill with hot water and the Rinse Tank will fill
with cold water. The liquid level controls will automatically turn off the hot water and the cold water
when the tanks are full.
9. Depress Detergent and Sanitizer prime buttons until chemicals are observed dripping into the Wash and
Rinse Tank respectively.
Note: The prime button overrides the pre-set adjustment and dispenses at full speed.
10. Turn Fill Switch to “off” position.
s
TarT
-u
p
I
nsTrucTIons
u
TIlITy
r
equIremenTs and
c
onnecTIons
GT-24
GT-30
2
3
4
1 2
4
3
1 = HOT WATER
2 = COLD WATER
3 = DRAIN
4 = ELECTRICAL
FRONT FRONT
1
CCW CW
3-3/4"
5-3/4"
1-1/4"
16"
12-1/16"
12-1/16"
2"
24-1/8"
12-1/16"
2"
3-3/4"
1-1/4"
12-1/16"
5-3/4"
16"
24-1/8"
FRONT FRONT
CCW CW
2
3
4
1
2
4
3
1 = HOT WATER
2 = COLD WATER
3 = DRAIN
4 = ELECTRICAL
1
3-1/2"
6-1/2"
30-1/8"
1-3/8"
19-3/8"
15-1/16"
15-1/16"
2-1/2"
20-3/8"
15-1/16"
3-1/2"
1-3/8" 2-1/2"
19-3/8"
6-1/2"
15-1/16"
20-3/8"
30-1/8"