Glastender GT-30 - Manual (Page 20)

Glastender, Inc. • 5400 North Michigan Road • Saginaw, MI • 48604-9780
800.748.0423 • 989.752.4275 • Fax 989.752.4444 • www.glastender.com
18
lIGhT c
leanInG
p
rocedures
:
a. With tanks drained, remove all debris.
b. Remove both Pump Inlet Screens.
c. With damp cloth, wipe the interior of both tanks.
d. Rinse the interior with clean water.
e. Rinse the Pump Inlet Screens with clean water.
f. Proceed to Step 11 below.
medIum c
leanInG
p
rocedures
:
a. With tanks drained, remove Wash Spray Box, Spray Box Gasket, and Pump Inlet Screens.
b. Remove all debris.
c. Thoroughly scrub and rinse all components removed from unit.
d. With a Scotch-brite pad, normally purchased in a grocery store, thoroughly scrub the interior of the unit.
The Top Section can be removed for ease of cleaning. Do NOT use steel wool.
e. Rinse the interior with clean water.
f. Proceed to Step 11 below.
HEAVY c
leanInG
p
rocedures
:
a. Reinstall Tank Plugs and Screens.
b. Turn Fill Switch to “on” position to fill Wash and Rinse Tanks.
c. Pour one cup of de-liming agent into the Wash Tank and one cup of de-liming agent into the Rinse Tank.
d. Reinstall Conveyor, Front Curtain(s), and Front Shield.
e. Allow the unit to reach operating temperature.
f. Turn Conveyor Switch to the “on” position.
g. Allow the unit to operate for 15 to 20 minutes.
h. Turn Conveyor Switch to the “off ” position.
i. Remove Front Shield, Front Curtain(s), and Conveyor.
j. Remove Tank Drain Plugs.
k. If lime has not been completely removed, repeat steps “a” through “j” above.
l. With all the lime removed, proceed to Medium Cleaning Procedures above. Follow steps “a” through “f ”.
11. Reinstall all components removed for cleaning except Conveyor, Front Curtain(s), and Front Shield.
See Figure 2, page 4.
12. Check Detergent and Sanitizer Containers. Refill or replace if empty.
13. Turn Fill Switch to the “on” position.
14. Visually inspect Detergent and Sanitizer Inlets while tanks are filling. Detergent and sanitizer should
be intermittently dripping.
15. Replace Conveyor, Front Curtain(s), and Front Shield.
16. Allow the unit to reach operating temperature.
17. Your glasswasher is now ready for operation.
c
leanInG
I
nsTrucTIons