Glastender GT-30 - Manual (Page 18)

Glastender, Inc. • 5400 North Michigan Road • Saginaw, MI • 48604-9780
800.748.0423 • 989.752.4275 • Fax 989.752.4444 • www.glastender.com
16
d
IaGnosInG
p
oor
w
ash
r
esulTs
The best way to understand why you are getting poor results is to know what components belong in your machine and how
they are supposed to operate. If you are getting poor results from your GT-24 or GT-30 glasswasher, follow these simple
steps to help diagnose your problem.
Possible Cause
1. The machine is dirty and/or the spray box holes are
clogged. The machine may require de-liming, because
of excess water deposit build-up.
2. The machine is missing components, like the wash and
rinse curtains or the rinse tank guide, which can cause
the wash and rinse water to mix or the rinse water to
be re-used.
3. The chemical feed lines are in the wrong chemical
container.*
4. The chemical containers are empty, so that no chemi-
cals are being dispensed into the glasswasher.*
5. The chemicals are in the wrong concentration. This is
usually evidenced by slimy or greasy feeling glasses,
even though all of the machine components are in
place and the chemical feed lines are in the proper
containers.*
6. The chemical tubing is disconnected or damaged and
leaking somewhere instead of getting into the wash or
rinse tank.*
7. Water is not spraying through the wash or rinse spray
box.
Remedy
1. Clean and/or de-lime the machine.
2. Replace missing components.
3. Put the chemical feed lines in the proper container.*
4. Get a new jug of chemicals. Pump priming may be
required.*
5. Contact your chemical vendor to have the concentra-
tion levels checked.*
6. Replace chemical tubing. Your chemical vendor may
help or contact your service company.*
7. The water recirculating pump is plugged or broke.
Have your service company inspect it.
* NOTE: Commercial dishwashing detergent and sanitizer are highly caustic and will burn human skin on contact.
Please exercise extreme caution when handling.