Glastender GT-30 - Manual (Page 11)

Glastender, Inc. • 5400 North Michigan Road • Saginaw, MI • 48604-9780
800.748.0423 • 989.752.4275 • Fax 989.752.4444 • www.glastender.com 9
11. Remove Drain Plugs allowing tanks to drain.
12. Adjust Detergent and Sanitizer Pumps. (See pages 9-10)
13. Replace Drain Plugs.
14. Turn Fill Switch to “on” position. The Wash and Rinse Tanks should now fill near the top of the
overflow walls. When the Wash Tank is full, the thermostatically controlled Heater will turn on and
off as necessary to maintain the water temperature at approximately 150° F.
NOTE: The Thermostat is preset at the factory.
15. Install Rinse Tank Guide (see Figure 2, page 4 - item 9).
16. Install Wash, Rinse, and Front Curtains (see Figure 1, page 3 - items 4, 5, and 6).
17. The unit is now ready to test detergent and sanitizer strength. Your chemical supplier will test the
concentration levels which are:
a. .30% for detergent, and
b. 50 PPM (parts per million) for chlorine bleach sanitizer, or
c. 12.5 PPM for iodine sanitizer.
Turn Conveyor Switch to “on” position for approximately 30 seconds to mix water and chemicals for
testing purposes. If further adjustment is necessary, refer to the next section on Peristaltic Pump Adjustment.
18. This glasswasher is equipped with an Empty Sensor for the Detergent and Sanitizer. Check the
operation by lifting the Detergent Feed Line from the Detergent container. This should turn on the visual
alarm. Place Detergent Feed Line back into Detergent container and repeat procedure for Sanitizer Feed Line.
19. Install Conveyor (see Figure 1, page 3 - item 3) and Front Shield (see Figure 1, page 3 - item 7). The Front
Shield clips to the Top Section.
20. Install front panel of Main Section (see Figure 1, page 3).
21. Your glasswasher is now ready for operation.
s
TarT
-u
p
I
nsTrucTIons
p
erIsTalTIc
p
ump
a
dJusTmenT
u
nITs
m
anuFacTured
b
eFore
J
anuary
2003 - d
IsconTInued
c
IrcuIT
b
oard
T
ype
1. Locate Peristaltic Pump in Glasswasher.
2. Locate Pump Control Circuit Board.
3. Each pump has its own adjustment dial.
One for Detergent and one for Sanitizer.
Turn dial clockwise for faster pump speed
or counter-clockwise for slower pump
speed.
1
2
3