Rugged Ridge Roof Rack, 07-14 Jeep 2-Door Wrangler - Manual (Page 3)

Copyright © 2013 Omix-Ada ® , Inc.
460 HORIZON DR. SUITE 400 | SUWANEE, GA 30024 | PHONE: 770-614-6101 | FAX: 770-614-6069 | [email protected]
11703.01/11703.02
Page 3/7
Figure 1
Installer is responsible for ensuring adequate silicone is used and applied correctly to all tub-
ing joints, bolt locations and wire grommets. Apply an even bead of silicone on the inside of
the female end. Insert the male end into tube. Silicone may also be used under bolt heads
and nuts for additional weatherproofing. The following symbol is a reminder:
Notice: If lights will be used, it is necessary
to run wire leads during steps 1-3 using pre-
drilled holes in the left windshield bracket
and front crossbar, shown in red below.
Use included rubber grommets and seal
with silicone.
NOTICE
NOTICE