Rugged Ridge Roof Rack, 07-14 Jeep 2-Door Wrangler User Manual
Page 5
Copyright © 2013 Omix-Ada
®
, Inc.
460 HORIZON DR. SUITE 400 | SUWANEE, GA 30024 | PHONE: 770-614-6101 | FAX: 770-614-6069 | [email protected]
7. Place rear tube into hinge bracket. (There are Left-hand
and Right-hand sides; tube should bend in towards fender
flare.) Insert the M12x85 bolt through the hinge and bushing
sleeve, and into the weldnut. Tighten bolt. Repeat for both
sides.
5. Install hinge brackets to each rear bracket using sup-
plied M8 bolts and washers. Ensure the weld-nut is facing
the body of the Jeep.
6. Grease bushings. Insert one into either side of a rear
tube opening. Insert metal sleeve into bushings. Repeat
for opposite side.
8. Install rear crossbar with supplied M10x65 bolts and nylon
lock nuts. The tube horn openings will face the front of the
vehicle. Do not tighten completely to allow for adjustment.
11703.01/11703.02
Page 5/7