Rugged Ridge Roof Rack, 07-14 Jeep 2-Door Wrangler - Manual (Page 4)

Copyright © 2013 Omix-Ada ® , Inc.
460 HORIZON DR. SUITE 400 | SUWANEE, GA 30024 | PHONE: 770-614-6101 | FAX: 770-614-6069 | [email protected]
Page 4/7
4. Remove rear bumper bolts. Slide rear bracket into
position and attach with the factory hardware. Repeat for
opposite side. Do not tighten completely to allow for ad-
justment in later steps.
Note: This rack is designed for use with Rugged Ridge® and
OE rear bumpers. Other aftermarket bumpers may require
complete removal of the bumper for installation or other
modifications.
2. Attach left and right brackets to front crossbar with sup-
plied M10x60 bolt and nylon lock nut. Do not tighten com-
pletely to allow for adjustment.
3. Install front crossbar assembly to vehicle using factory
hardware retained from Step 1. Do not tighten completely
to allow for adjustment.
1. Remove the factory left and right windshield brackets. Re-
tain factory hardware for later use.
CAUTION !
Use of tape on the a-piillar, cowl, and fender
is recommended to prevent damage to
vehicle’s finish.
Two people are also recommended for this
step: One on each side.
11703.01/11703.02