Rugged Ridge Roof Rack, 07-14 Jeep 2-Door Wrangler - Manual (Page 7)

Copyright © 2013 Omix-Ada ® , Inc.
460 HORIZON DR. SUITE 400 | SUWANEE, GA 30024 | PHONE: 770-614-6101 | FAX: 770-614-6069 | [email protected]
13. Assemble the rubber bumper assembly as shown. Use
the washers to move the bumper inward enough to con-
tact the body. Bumper should have slight tension against
vehicle to prevent rack from swaying.
Tilting the Rack. To tilt the rack, attach the safety lanyard to the hole on the top bracket and the
other end to the side hole on the landing pads of the front crossbar. Slowly tilt the rack until the
lanyard is holding the rack from continuing.
DO NOT attempt tilting rack while loaded. Serious injury or death
may occur. WARNING !
Page 7/7
11703.01/11703.02