SawStop SawStop - Manual (Page 10)

10
1.
Turn the saw OFF and unplug the power cord.
.
Set the blade to 0°, raise it fully and remove the
table insert.
3.
Remove the blade nut and washer. Place the open
end of one blade wrench on the flat sides of the arbor.
Place the closed end of the other wrench over the nut.
Turn the nut counter-clockwise to loosen.
4.
Install the blade with the teeth pointing forward (as shown).
Note: If you are installing a dado set, first install a dado brake cartridge.
5.
Install the washer and the nut for a 10” blade; install the nut without the washer for
dado sets over 1/4” thick. Using the wrenches, turn the nut clockwise to tighten.
6.
YOU ARE NOT DONE. You must now check the blade-to-brake spacing (see page 11).
nut
washer
arbor
Changing the Blade
See Owner’s Manual
?
p.27
WARNING:
Never install the blade backwards.
!