SawStop SawStop - Manual (Page 2)


What are you cutting?
If you don’t know whether the material you are about to cut is
conductive, perform the material conductivity test on page 5.
Not Sure?
Run the saw in Normal Mode
to cut non-conductive materials
like wood, plastic, cardboard,
foam, Corian, melamine and
dry pressure-treated wood.
Run the saw in Bypass Mode
to cut conductive materials like
metal, very wet or very green wood,
Carbon-filled materials, mirrored
acrylic, carbon fiber materials and
wet pressure-treated wood.
For Normal Mode go to page 3. For Bypass Mode go to page 4.