SawStop SawStop - Manual (Page 11)

11
Adjusting the Blade-to-Brake Spacing
Always adjust the blade-to-brake spacing after
installing a blade or brake cartridge.
See Owner’s Manual
? pp.28-29
1.
Turn the saw OFF and unplug the power cord.
.
Remove the table insert.
3.
Place the yellow spacing gauge between the blade
and the brake as shown (or use a nickel instead).
The gauge should just fit between the blade and the brake.
4.
To DECREASE the spacing, turn the yellow bolt CLOCKWISE .
To INCREASE the spacing, turn the bolt COUNTER-CLOCKWISE .
(Use the 8 mm hex key included with saw.)
5.
With the saw off, spin the blade by hand two full
revolutions to make sure no tooth touches the brake.