SawStop Mobile Base - Manual (Page 2)

1 SawStop Contractor Mobile Base
Unpacking Your Mobile Base
Safety
While unpacking your mobile base verify that all the components shown on this page are included.
release lever
3” caster
(two)
3” wheel
(two)
caster support plate
linkage bar
caster support
wheel support
mobile base hardware pack owner’s manual
SawStop
SawStop ®
OWNER’S MANUAL
Contractor Mobile Base
Low er
Raise Never place fingers, toes or other body parts under the mobile base. ! WARNING 1. Ne ver plac efinge rs, toe sor othe r body partsun der th e m obile base. 2. Alw ays uset he sawa nd the mobile base o n aleve l surfa c e. 3. Lo wer the saw be fore u s saw when i t i s raise d off 4. Lo wer the sawsl drop back to . ! WARN ING
Model MB-CNS-000
Mobile Base Hardware Pack
Nylon Hex Nuts, M6 (2) 4 Lock Washers, M8 x 13.6 (4) 6
Flange Lock Nuts, M6 (2) 9
Shoulder Socket Screw, M8 x 17.7 (1) 15
Shoulder Socket Screw, M8 x 15.7 (1) 13
Nylon Hex Nut, M8 (1) 19 Cap Nut, M8 (1) 20
Extension Spring, (1)
17
Hex Bolts, M8 x 40 (2) 8
Caster Nuts, 3/8” thread (2) 12
Wave Washer, M10.5 x 14.5 (1) 16
Short Fixed Wheel Axle, M6 x 67.6 (1) 1 Long Fixed Wheel Axle, M6 x 73.8 (1) 2
Washers, M6 x 16 (4) 3 Button Head Socket Screws, M8 x 20 (4) 5
Washers, M8 x 18 (4) 7
Hex Screw, M8 x 30 (1) 14
Release Lever Locking Screw (1) 18
Lock Washers, M10.5 x 17 (2) 11
Washers, M10.5 x 25 (2) 10
Low er Raise Never place fingers, toes or other body p arts under t hemobile base. ! WARNING 1. Neve r place fingers , t oes or ot her body p arts un der the m o bile ba se. 2. Alw ays use t h e saw a nd the mobil e baseon a level surface. 3. Lo wer the sa wbefore using saw w hen it is rais ed off 4.Lowe r t hesaw s lo drop b ack to . ! WARNIN G
1. Never place fingers, toes or other body parts under the saw when it is raised onto the mobile base. The base
may suddenly lower on you and cause a severe injury.
2. Do not attempt to use or move the saw on an inclined surface. The weight of the saw makes it difficult to stop on
an inclined surface. Attempting to use or move the saw on an inclined surface could result in a severe injury.
3. Make sure the saw is fully lowered to the ground and stable before operating the saw. Otherwise, the saw could
move unexpectedly and cause a severe injury.
4. Be sure to unplug or disconnect the saw from power before moving or repositioning it. The main power cord or
the power outlet could be damaged if the saw is not disconnected from power before moving it.
Note: If you are using the SawStop Out-Feed Table you must remove it before moving your saw with the Contractor
Saw Mobile Base. Attempting to lift the saw with the out-feed table attached may damage the out-feed table.