SawStop Mobile Base - Manual (Page 4)

9
9
3
8
3
8
Installing Your Mobile Base
5
6
7
5
6
7
Installing Your Mobile Base
Fig. 4a
Fig. 5
3 SawStop Contractor Mobile Base
4. Each end of the wheel support has a cylindrical projection. Mount the wheel support to the left side of the stand
by inserting the cylindrical projections into corresponding mounting holes in the legs of the stand, and then
securing the support to the stand with two M8 x 20 button head socket screws, two M8 lock washers, and two
M8 washers, as shown in Figs. 4a and 4b. Fully tighten the two M8 x 20 button head socket screws using a 5
mm hex key. When you mount the support to the stand, make sure the foot pedal is extending out to the left.
5. Position the caster support plate on top of the
caster support as shown in Fig. 5. Note that
the connecting lever on the caster support
and the SawStop logo on the support plate
both face up. Secure the support plate to the
caster support with two M6 x 40 hex bolts,
two M6 washers, and two M6 flange lock
nuts. Fully tighten the two M6 x 40 hex bolts
using two 10 mm wrenches.
connecting
lever
caster support
plate
caster
support
Fig. 4b
cylindrical
projection
mounting
hole