SawStop Mobile Base - Manual (Page 7)

Installing Your Mobile Base
15 16
18
17
14
Fig. 11
Fig. 12
Fig. 13
SawStop Contractor Mobile Base 6
11. Locate the release lever and the M8 x 30 hex screw and
fully thread the screw into the threaded hole in the release
lever (see Fig. 11).
release
lever
12. The release lever attaches to the foot pedal arm of
the wheel support. The release lever includes a non-
threaded hole, roughly in the middle of the lever, that
aligns with a threaded hole in the foot pedal arm, as
shown in Fig. 12. Place the M10.5 x 14.5 wave washer
over the shoulder of the M8 x 17.7 shoulder socket
screw. Then insert the shoulder socket screw through
the non-threaded hole in the release lever so that the
hole fits over the screw’s shoulder, and then thread the
screw into the hole on the foot pedal arm. Fully tighten
the screw with a 5 mm hex key.
release lever
foot
pedal
arm
13. Locate the extension spring and the release lever locking screw. Note
that the screw has two shoulders, one with a larger diameter next to the
head, and one with a smaller diameter next to the threads. Slide one end
of the extension spring over the larger shoulder (see Fig. 13).
larger shoulder
threaded hole
non-threaded
hole