SawStop Mobile Base - Manual (Page 5)

Installing Your Mobile Base
5
6
7
5
6 7
Fig. 6a
Fig. 7
Fig. 6b
SawStop Contractor Mobile Base 4
6. The caster support must be positioned inside the stand. If your contractor saw is not yet on the stand, then lift
the right side of the stand a few inches off the floor and slide the caster support into position between the two
right legs, as shown in Fig. 6a. Make sure that the SawStop logo on the support plate is facing up and that
the connecting lever is on the inside of the stand. If your contractor saw is already mounted to the stand, you
can remove the lower bracket on the right side of the stand and angle the caster support into place as shown
in Fig. 6b. Once the caster support is in place, reinstall the bracket that you removed.
7. Each end of the caster support has a cylindrical projection. Mount the caster support to the right side of the
stand by inserting the cylindrical projections into corresponding mounting holes in the legs of the stand, and
then securing the support to the stand with two M8 x 20 button head socket screws, two M8 lock washers, and
two M8 washers, as shown in Fig. 7. Fully tighten the two M8 x 20 button head socket screws using a 5 mm
hex key. Make sure that the SawStop logo on the support plate is facing up and that the connecting lever is on
the inside of the stand.
lift up the stand
and slide the caster
support into place
remove the lower
bracket on the right side
and angle the caster
support into place