SawStop Mobile Base - Manual (Page 8)

Installing Your Mobile Base
19
20
Fig. 16
Fig. 15
Fig. 14
7 SawStop Contractor Mobile Base
Congratulations, your mobile base is now installed.
14. The end of the release lever opposite the foot
pedal includes a slot. Pivot the release lever
until the slot aligns with the plastic washer
and threaded hole in the middle of the
linkage bar. Insert the release lever locking
screw through the slot in the release lever
and thread it into the hole in the linkage bar,
making sure to keep the extension spring
on the screw (see Fig. 14). Fully tighten the
release lever locking screw with a 5 mm hex
key.
15. Locate the M8 nylon hex nut and thread it onto
the release lever locking screw to hold the screw
in place as shown in Fig. 15. Fully tighten the nut
with a 13 mm wrench.
16. Stretch the free end of the extension spring over
the end of the M8 x 30 hex screw that extends
from the release lever. Thread the M8 cap nut
onto the M8 x 30 hex screw to hold the extension
spring in place (see Fig. 16) , and fully tighten
the cap nut with two 13 mm wrenches.
release lever slot