SawStop T-Glide Fence System - Manual (Page 5)

Installing Your T-Glide Fence System
1
2
3
4
SawStop
System Status Cod es
Status Red Grn
¯ ¯ ¯
Wet Wood Overload Due To
During Bypass Contact Det ected
During Stan dby
Contact De tected
Brake Adjust Position of Doors Close Access Key To “On” Turn Cartridge To “Off” Turn Start Switch Bypass Mode On
Coasting Down
Replace Ca rtridge
System Ready
System Initializing
• • • • • •
¯ ¯ ¯
¯ ¯ ¯
• • • • • •
¯ ¯ ¯ • • • • • •
• • • • • • • • • • • •
• • • • • •
¯ ¯ ¯
• • • • • •
0 15
30
45
SawStop
10” Contractor Saw
3. Place an M8.5 x 23 washer and an M8 lock washer
on the back of each of the six M8 x 25 countersunk
socket head bolts, and then thread an M8 hex nut on
each bolt (see Fig. 3). Hand tighten the nuts; do not
fully tighten them.
Fig. 3
4. The holes in the front edge of the table and extension wings are slightly larger than the bolts they receive to
allow you to level the front rail and extension wings to the table top. Align the top of the front rail with the lower
edge of the bevel on the front edge of the table top (see Fig. 4). Use a 5 mm hex key and a 13 mm wrench to
fully tighten the nuts on the back of the four bolts that extend through the table top. Do not tighten the nuts on
the bolts that extend through the extension wings.
level the top of
the front rail with
the lower edge
of the bevel Fig. 4
5. Use a straight-edge to level the front edge of the left extension
wing to the cast iron table top (see Fig. 5). You may have to
pull up or push down on the outer edge of the extension wing
to level it. Once the front edge of the left extension wing is
level, use a 5 mm hex key and a 13 mm wrench to fully tighten
the nut on the bolt that mounts the left extension wing to the
front rail. Repeat this process to level the front edge of the
right extension wing.
level the extension
wing and tighten the
nut on this bolt
straight-edge
Fig. 5
bevel
tighten
SawStop T-Glide Fence System - Professional Series 3