SawStop T-Glide Fence System - Manual (Page 7)

13
14
15
16
SawStop, the SawStop blade logo, and the
configuration of this product are either reg istered
trademarks or trademarks of SawStop, LLC.
Software copyright 2003-2006 by SawStop, LLC .
All rights reserved . Protected by one or more of
the following U.S. patents 6813983, 68269 88,
6857345, 6877410, 6880440, 692 0814, 69451 48,
6945149, 6957601, 6994004, 69 97090, 7000 514,
7024975, 70554 17, 7077039, 7098800, 7100483,
7137326, 717187 9, 7197969, 7210383, 72 25712,
7228772, 7231856 and Taiwan patent 14346 6.
Additional U.S. and foreign patents pending.
! WARNING
Do not remo ve the dust shroud because
the blade will be exposed. If you contact the
blade under the table, the blade may retract
toward you and cause a severe injury .
Installing Your T-Glide Fence System
Fig. 8
8. Use a straight-edge to level the rear edge of the
left extension wing to the cast iron table top (see
Fig. 8). You may have to pull up or push down on
the outer edge of the extension wing to level it.
Once the rear edge of the left extension wing is
level, use a 5 mm hex key and a 13 mm wrench
to fully tighten the nut on the bolt that mounts
the left extension wing to the rear rail. Repeat
this process to level the rear edge of the right
extension wing.
9. Once the rails are in place you can mount the extension
table to the rails, but first you must mount the support
leg or legs to the extension table. The extension
table for the 36” fence system has one support leg
and the extension table for the 52” fence system has
two. Locate the support legs, the angle brackets, and
the T-Glide table hardware pack. Begin by installing
the adjustable foot in the bottom of each support leg.
Thread an M8 nut onto the threaded shaft of the foot
as close to the rubber base as possible, and then
thread the foot into the bottom of the support leg as
far as possible (see Fig. 9).
Fig. 9
Fig. 10
10. Each support leg is mounted to the underside of the extension table using two angle brackets. Align the two
holes in the support leg to the two holes in the brackets as shown in Fig. 10. Put one of the M10 x 45 hex head
bolts through each hole in the leg and brackets.
Thread an M10 nylon lock nut on each bolt and
tighten with a 17 mm wrench. You will need to
hold the head of the hex bolt with another 17
mm wrench to tighten the lock nut. Do not fully
tighten the nuts; leave them just loose enough to
be able to move the brackets.
level the extension
wing and tighten the
nut on this bolt
angle bracket
support
leg
straight-edge
18
Countersunk Socket
Head Bolts, M8 x 25 (6)
Washers,
M8.5 x 23 (6) 19
Lock Washers,
M8 (6) 20
Philips Head Screws,
M4 x 16 (12) 17
Foot,
(2) 13
Hex Head Bolts,
M10 x 45 (4) 15
Hex Nuts,
M8 (8) 14
Nylon Lock Nuts,
M10 (4) 16
T-Glide 52” Table Hardware Pack
SawStop T-Glide Fence System - Professional Series 5