SawStop T-Glide Fence System - Manual (Page 9)

0
15
30
45
SawStop
10” Contractor Saw
18
19
20
14
0 15 30
45
SawStop
10” Cont ractor Saw
Installing Your T-Glide Fence System
13. Insert an M8 x 25 countersunk socket head bolt through each remaining hole in the front and rear rails and
through the notches in the front and rear edges of the extension table. Place an M8.5 x 23 washer and an
M8 lock washer on the back of each bolt and then thread an M8 hex nut on each bolt (see Fig. 13). Hand
tighten the nuts; do not fully tighten them.
14. If you loosened the rear rail in step 12, tighten it now. If necessary, level the extension wings before tightening
(see step 8 for information about leveling the extension wings). Once the rear rail is tightened, make sure
the extension table is flush against the right extension wing and there is no gap between them. Then, use a
straight-edge to level the front edge of the extension table to the cast iron table top (see Fig. 14). You may have
to pull up or push down on the outer edge of the extension table to level it. Once the front edge of the extension
table is level, use a 5 mm hex key and a 13 mm wrench to fully tighten the nuts on the bolts that mount the
extension table to the front rail.
Fig. 13
Fig. 14
straight-edge
SawStop T-Glide Fence System - Professional Series 7