SawStop T-Glide Fence System - Manual (Page 8)

Installing Your T-Glide Fence System
0 15 30
45
SawStop
10” Contrac
tor Saw
17
11. Mount the angle brackets to the underside of the extension
table using three M4 x 16 Phillips head screws per bracket (see
Fig. 11). The underside of the extension table is pre-drilled to
receive the screws. Be careful not to overtighten the screws
because you may strip the threads in the wood. Once all the
brackets have been mounted to the table, fully tighten the M10
nylon lock nuts that secure the legs to the brackets.
Fig. 11
12. The next step of the assembly is easiest with two people. Position the extension table between the front and
rear rails. The support legs should be at the far end of the rails, away from the saw (see Fig. 12). If you are
having trouble fitting the table between the rails you can loosen the screws and bolts that mount the rear rail
to the saw so that you can move the rear rail out slightly while you position the extension table between the
front and rear rails. Align the holes in the front and rear rails with the notches in the front and rear edges of the
extension table.
Fig. 12
6 SawStop T-Glide Fence System - Professional Series