SawStop Sliding Crosscut Table - Manual (Page 10)

SawStop TSA-SA48 Sliding Crosscut Table | 6
Mounting the Sliding Table Attachment to Your Saw
Before continuing, make sure the sliding table top is locked to the sliding table assembly. If the sliding table top
is not locked, pull out the sliding table lock knob on the bottom of the table assembly and rotate it 90 degrees,
then release. Slowly slide the table top toward the Home Position. The Home Position is where the front of the
sliding table top is generally flush with the table bottom. The lock knob should engage the table top and lock it
against further movement. This will help prevent injury due to the sliding table top moving unexpectedly.
1. Turn the sliding table assembly upside down, slide the support leg T-bolts (109) into the sliding table T-slot
(see Fig. 4), then hand-tighten the legs clockwise to secure them in place.
Fig. 4
Note: For the best support, position the legs near the edges of the sliding
table, as shown in Fig. 4.
2. For PCS and CNS saws ONLY: Attach the switch box mounting bracket (113) to the underside of the sliding
table assembly using three M6x1.0x16 cap screws, three M6 washers and three M6 lock washers as shown
in
Fig. 5.
Fig. 5