SawStop Sliding Crosscut Table - Manual (Page 2)

If your table saw is not yet assembled, follow these instructions in place of the instructions on Page 4 of the
Owner’s Manual for modifying your saw rails before assembling your table saw and attaching your Sliding
Crosscut Table.
1. Set out the front rail, rear rail, and main tube. (Contractor Saw w/ 30” TSA-SFA does not have a front rail)
2. Mark the front rail, rear rail, and main tube, measuring from the left end. Refer to the table below for the
correct measurements, and the diagram at the bottom of the page to determine the left end of the rails.
Note: To orient the tube properly, ensure the ruler is right side up when you are facing
the tube. Then, measure and cut from the left end.
3. Use a metal cutting band saw to cut the front rail, rear rail, and main tube at the marks made in the previ-
ous step.
Note: Using other types of saws (such as a circular saw) can generate enough heat to
blister the powder coating.
4.
Remove any burrs or sharp edges with a file. Remove cap from end of rail and reinstall on new cut end.
5. Install the front rail, rear rail, and main tube as you normally would when assembling your table saw, using
the instructions provided with your saw. In your Sliding Crosscut Table Owner’s Manual, proceed with setup
starting at Page 5, Steps 10-12.
Reminder: The Sliding Crosscut Table takes place of the left wing.
Example of a Rear Rail
Example of a Front Rail
Approximate Cut Location
Approximate Cut Location
Contractor Saw
Rip Capacity Front Rail Main Tube Rear Rail
30” (TSA-SFA) 13 1/4 10 1/2
36” (TGP2-36) 13 5/8 13 5/8 12 3/8
52” (TGP2-52) 13 5/8 13 5/8 12 3/8
Rip Capacity Front Rail Main Tube Rear Rail
30” (TSA-PFA) 12 5/8 12 5/8 11 3/8
36” (TGP2-36) 12 5/8 12 5/8 11 3/8
52” (TGP2-52) 12 5/8 12 5/8 11 3/8
Rip Capacity Front Rail Main Tube Rear Rail
36” (TGP2-36) 10 11/16 10 11/16 10 9/32
52” (TGP2-52) 10 11/16 10 11/16 10 9/32
Industrial Cabinet Saw
Professional Cabinet Saw
Modifying Your Unassembled Table Saw