SawStop Sliding Crosscut Table - Manual (Page 11)

SawStop TSA-SA48 Sliding Crosscut Table | 7
3. With the help of at least one other person to support the weight, turn the sliding table assembly over and
position it against the side of the saw table.
4. Adjust the height of the sliding table to approximately match the saw table by turning the foot pads on the
bottom of the leg assemblies.
5. Visually align the mounting holes in the side of the sliding table assembly with the holes in the side of the
saw table and then mark the set of holes to be used. See Fig. 6 for PCS and CNS saws, or Fig. 7 for ICS
saws.
Fig. 6
(PCS and CNS saws have 4 mounting holes)
Fig. 7
(ICS saws have 3 mounting holes)