SawStop Sliding Crosscut Table - Manual (Page 9)

SawStop TSA-SA48 Sliding Crosscut Table | 5
Note: Steps 10—12 apply only to CNS saws.
10. On CNS saws it is necessary to increase the slack in the motor power cord in order to move the switchbox to
the new mounting position. The first step is to remove the motor power cord from the strain relief on the rear
of the saw (see
Fig. 1). Remove the three screws that mount the strain relief to the rear of the saw frame.
Remove the cord connected to the motor and replace the strain relief. Make sure the AC power cord is
captured by the strain relief.
Fig. 1
11. If your CNS saw is mounted on a Mobile Cart as shown in Fig. 2, simply route the motor power cord
underneath the upper frame of the Mobile Cart.
Fig. 2
12. If your CNS saw is mounted on the CNS stand, it is necessary to create a 2” diameter hole in the rear panel
of the stand. The center point of the hole should be located as shown in Fig. 3. SawStop recommends using
a 2” hole saw to form the hole in the rear panel. Finally, snap the supplied 2” grommet (257) into the hole
and feed the cord from the motor through the grommet then reconnect it with the motor power cord.
Fig. 3