Actiontec electronic R4500U - Manual (Page 8)

5
Setting Up
The Modem
The instructions that follow parallel the steps contained in the Actiontec Installation
Buddy
™ , which provides a visual guide to setting up the Modem. It is recommended
the user run the Installation Buddy first, before attempting any other procedures.
To set up the Modem, connect it to a computer. After connecting this first com-
puter, other computers can be added to the network via
USB , Ethernet, or wireless-
ly (see “Connecting Additional Computers on page 21).
☞
Note: The Installation Buddy is not supported on computers
running Windows 95 and NT 4.0, Macintosh, or Linix operating
systems.
Connecting a Computer to the Modem
Connecting a computer to the Modem for setup involves three basic steps: initial
setup, plugging in the Modem’s Power Cord, and connecting the Modem to the
computer.
☞
Note: The following procedures are for U.S. installations only.
Connecting Via Ethernet
1. Insert Disk 1 (Installation Buddy CD) in the CD-ROM drive of the computer.
The Installaton Buddy will start automatically. Wait until the following screen
appears, read the onscreen instructions, then click Next.
2