WIKA CPC3000 - Manual (Page 48)

Pneumatic High-Speed Pressure Controller CPC3000
WIKA Operating Instruction Pneumatic High-Speed Pressure Controller ∙ Version 1.1 48
11498171.01 08/2009 GB
Command Data Response/Function
Vent None Instrument placed in Vent Mode.
Vent? <sp>(Yes or No)<cr><lf> Returns Yes if instrument is in Vent, No
if otherwise.
Window Value in current units Sets the exponential filter window for
the active sensor.
Window? <sp>n.nnnnne+nn<cr><lf> Returns the exponential filter window
for the active sensor.
Zero desired pressure or ? Sets zero to set pressure or for ?,
clears previous value.
Zero? <sp>xxxxxxx<cr><lf> Returns zero offset for active trans-
ducer.
8.5.2 PCS 400 Commands Emulated
Command Data Response/Function
_pcs4 autorange <value> 0 or 1 1 turns autorange on, 0 – off.
_pcs4 autorange? Returns 1 if in autorange, 0 if in
range hold.
_pcs4 cal a/d Not applicable.
_pcs4 cal atm Performs pcs400 1 pt cal.
_pcs4 cal span <value> Sets the span of the active trans-
ducer to <value>.
_pcs4 cal zero <value> Sets the zero of the active trans-
ducer to <value>.
_pcs4 cal_disable_off Enables zero or span calibrations if
previously disabled.
_pcs4 cal_disable_on Prevents zero or span calibrations.
_pcs4 ctrl <value><sp><unitno> Sets control value – will take effect
immediately if instrument is in
control mode.
_pcs4 ctrl? Returns the current control point in
current engineering units.
_pcs4 ctrlmax <value> Sets maximum control value.
_pcs4 ctrlmax? Returns current maximum control
pressure.
_pcs4 ctrlmin <value> Sets minimum control value.
_pcs4 ctrlmin? Returns current minimum control
pressure.
_pcs4 emul? Returns ptype emulation mode.
_pcs4 default Sets default values into instrument.
_pcs4 err? Returns the error number and
description.
_pcs4 exhaustp? Returns exhaust pressure.