WIKA CPC3000 - Manual (Page 54)

Pneumatic High-Speed Pressure Controller CPC3000
WIKA Operating Instruction Pneumatic High-Speed Pressure Controller ∙ Version 1.1 54
11498171.01 08/2009 GB
Command Response/Function
:UNIT
[:NAME]? Returns ASCII units (mixed case)
:VALue? Returns the units conversion factor
:REFerence
[:HEIGht] <n> Sets the head pressure height
:MODE? Returns “OFF”, “GAS”, or “LIQUID”
:MODE OFF | GAS | LIQUID Sets the head pressure mode
:MEDium <n> Sets the medium density
SYSTem
:DATE <i,i,i> Sets sytem date YY,MM,DD
:TIME <i,i,i> Sets system time HH,MM,SS
:ERRor[:NEXT]? Returns error code, description
:KLOCk ON | OFF | 1 | 0 Sets the keylock state
:PRESet Load known state values
:SAVe No function (not needed)
:VERSion? Returns SCPI version 1994.0
TEST
:ELECtronic? Returns “OK”
:RELay <n>? Returns status of digital output <n> ignored
:RELay <n> ON | OFF Turns the digital output on or off <n> ignored
UNIT
:NAME <n>? Returns the units string for units code <n>
:FACTor <n>? Returns the units conversion for units code <n>
OUTPut
:STATe ON | OFF | 1 | 0 ON or 1 = Control OFF or 0 = Measure
:STATe? Returns 0 for measure 1 for control
:MODE MEASure | CONTrol | VENT Sets the mode indicated
:MODE? Returns the mode string
:STABle? Returns 1 if stable 0 if not
:AUTOvent ON | OFF | 1 | 0 Puts the unit in the Vent mode if true
:AUTOvent? Returns the state of the Vent mode
[SOURce]
:PRESsure
[:LEVel]
[:IMMediate]
[:AMPLitude] <n> Sets the setpoint
[:AMPLitude]? Returns the setpoint
:SLEW <n> Sets the rate setpoint
:SLEW? Returns the rate setpoint
:TOLerance? Returns the stable window
:TOLerance <n> Sets the stable window