RADWAG WLY Scales - Manual (Page 45)

45
15.2. ETHERNET setting
Procedure:
• Enter <
Communication>
according to ch.15 of the manual,
select <
Ethernet>
and then set an appropriate value.
Following settings are accessible for Ethernet:
• DHCP - Yes – No
• IP Address - 192.168.0.2
• Subnet Mask - 255.255.255.0
• Default gateway - 192.168.0.1
• DNS - 192.168.0.1
• MAC Address - ---
Notice:
1. The above settings are presented for information purpose only.
Transmission parameters have to be selected in accordance with
client’s local network settings.
2. Parameter <MAC Address> is automatically assigned to a device
and it is has <Read only> Attribute.
3. In case of declaring the <DHCP> parameter to value and on device
restart, the other transmission parameters have <Read only> attribute.
•
After making changes press key, then a new message is displayed:
<Restart to apply the changes>
,
•
Go back to weighing and restart the device.
15.3. TCP protocol setting
TCP (Transmission Control Protocol) is a protocol for communication
between two computers. It operates in mode client-server. Server awaits
on connection iniciation on a specified port while client initiates connection
to the server. Scale software allows setting the port for the „Tcp” protocol.