RADWAG WPW 60/H5/K Multifunctional Scales - Manual (Page 169)

8. In order to add / edit an ingredient press :
Caution:
It is advisable that if external automatic systems controlled by PUE
C41 terminal outputs are used (see point 5) the text boxes above
have following interpretation. Threshold1 is the limit of the bulk
dosing and Mass (nominal) is the limit of the precise dosing.
Threshold2 is a warning limit over which the dosing procedure
is stopped and the next ingredient does not start. The dosing
procedure cab be continued after the stable result lower or
greater than Mass and greater than Threshold1 is measured.
9. After entering all the required changes save them by pressing
.
10. All changes in parameters needs to be saved in the scale
by pressing .
11. Press on the terminal to select a recipe you want to process.
12. Press START on the control desk or on the terminal keypad
to start the dossing process.
13. The program performs tarring.
14. The bulk dosing of the first ingredient is started, both outputs
prescribed to the ingredient are on. When the mass indication
reaches values over Threshold1 one of outputs is switched off that
causes decreasing the rotation speed of the motor and dosing is
slower. This method of dosing is more precise and effective than the
single threshold method of dosing an ingredient with constant speed.
15. Threshold values are declared in recipes. Equivalent rotation
speeds are declared in inverters.
- 169 -