Cirrus Logic CDB48500-USB - Manual (Page 12)

3
B. Connect the other end of the optical cable to the optical output on the back of a DVD player or other
digital audio source.
5. Setup Audio Output connections from CDB48500 as follows:
A. The RCA connectors labeled AOUT_1A and AOUT_1B are the left and right analog output channels.
B. Use the RCA audio cables to connect these line-level analog outputs to powered speakers.
2.1.3 Connecting to a PC
Follow these steps to connect to a PC:
1. Connect the “B” end of the USB cable to P1 on the CDB USB MASTER USB Digital I/O Card.
2. Connect the “A” end of the USB Cable to a USB 2.0 port on a notebook or PC running Win XP.
3. Windows

should recognize that a new device has been attached and display a notice saying “Found New
Hardware”.
Figure 2-3. Found New Hardware Service Window
4. Windows will display the Found New Hardware Wizard (below). Select the No, not at this time radio button
so that Windows does not connect to Windows Update for the drivers. Click Next.
Figure 2-4. Found New Hardware Wizard Welcome Window
5. Windows will then ask whether to use automatic installation or manual installation. Allow Windows to install
the software automatically and click Next.