MSI 880G-E45 - Manual (Page 19)

2-3
MS-7576
Chapter 2
RESET CMOS
Clr
S
O
C
K
E
T
A
M
3
Screw Holes
When you install the mainboard, you have to place the mainboard into the chassis in the
correct direction. The locations of screws holes on the mainboard are shown as below.
Refer above picture to install standoffs in the appropriate locations on chassis and then
screw through the mainboard screw holes into the standoffs.
Important
To prevent damage to the mainboard, any contact between the mainboard circuit and
chassis or unnecessary standoffs mounted on the chassis is prohibited.
Please make sure there is no metal components placed on the mainboard or within
the chassis that may cause short circuit of the mainboard.
•
•
Screw holes
The side has to to-
ward the rear, the
position for the I/O
shield of the chas-
sis.