MSI 880G-E45 - Manual (Page 30)

2-14
Hardware Setup
Fan Power Connectors: CPUFAN1, SYSFAN1~3
The fan power connectors support system cooling fan with +12V. When connecting the
wire to the connectors, always note that the red wire is the positive and should be con-
nected to the +12V; the black wire is Ground and should be connected to GND. If the
mainboard has a System Hardware Monitor chipset on-board, you must use a specially
designed fan with speed sensor to take advantage of the CPU fan control.
1.Gro
und
2.+1
2V
3.No
Use
1.Gro
und
2.+1
2V
3.Se
nsor
1.Gro
und
2.+1
2V
3.Se
nsor
4.Co
ntrol CPUFAN1 SYSFAN3 SYSFAN1~2
Important
Please refer to the recommended CPU fans at processor’s official website or consult
the vendors for proper CPU cooling fan.
CPUFAN1 supports fan control. You can install Overclocking Center utility that will
automatically control the CPU fan speed according to the actual CPU temperature.
Fan cooler set with 3 or 4 pins power connector are both available for CPUFAN1.
S/PDIF-Out Connector: JSP1
This connector is used to connect S/PDIF (Sony & Philips Digital Interconnect Format)
interface for digital audio transmission.
* The MB layout in this figure is for reference only.
S/PDIF-Out Bracket (optional)
•
•
•