AMX NETLINX MASTER NXC-ME260 - Manual (Page 42)

NetLinx Security
38 NXC-ME260 NetLinx Master-Ethernet Card/Module
10) Show List of Authorized Groups
1. Type 10 and <ENTER> at the Security Setup prompt (at the bottom of the Main Security
Menu) to display a list of all authorized group accounts. A sample session response is:
The following groups are currently enrolled:
administrator
Group 1
Press <ENTER> key to continue
2. Press <ENTER> to return to the Security Setup Menu.
11) Set Telnet Timeout in seconds
1. Type 11 and <ENTER> at the Security Setup prompt (at the bottom of the Main Security
Menu) to set the Telnet Timeout value, in seconds. A sample session response is:
Specify Telnet Timeout in seconds:
2. Enter the number of seconds before you want The Telnet session to timeout, and press
<ENTER> to return to the Security Setup Menu.
12) Display Telnet Timeout in seconds
1. Type 12 and <ENTER> at the Security Setup prompt (at the bottom of the Main Security
Menu) to view the current Telnet Timeout value (in seconds). A sample session response is:
Telnet Timeout is 10 seconds.
2. Press <ENTER> to return to the Security Setup Menu.
13) Make changes permanent by saving to flash
When changes are made to the security settings of the master, they are initially only changed in
RAM and are not automatically saved permanently into flash. This selection saved the current
security settings into flash. Also, if you attempt to exit the Main Security Menu and the security
settings have changed but not made permanent, you will be prompted to save the settings at that
time.
Type 13 and <ENTER> at the Security Setup prompt to (permanently) save all changes to flash.
Reboot the Master for the security configuration changes to take effect.