Norgren 4111 Series - Manual (Page 2)

1-3/4
VALVE CAN BE MOUNTED
ON EITHER SURFACE
Ø 0.28 ± 0.02 MOUNTING HOLE
TYP. 2 PL
1/8-27 NPTF INTERNAL
THREAD, (ALL PORTS)
2-7/16 1-1/2
1
EXHAUST
SHIELD
Ø 0.28 ± 0.02 MOUNTING HOLE
TYP. 2 PL
1
Warning
Improper selection, misuse, age or malfunction of components used in
commercial vehicle systems can cause failure in various modes. The system
designer is warned to consider the failure modes of all component parts
used in commercial vehicle systems and to provide adequate safeguards to
prevent personal injury or damage to equipment or property in the event of
such failure modes. System designers and end users are cautioned to consult
instruction sheets and specifications available from the factory. The system
designer/end user is responsible for verifying that all requirements for the
application are met.
Warranty
The products described herein are warranted subject to seller’s Standard
Terms and Condition of Sale, available at seller’s website.
Our policy is one of continued research and development. We therefore reserve the right to amend,
without notice, the specifications given in this document.
© Norgren GT Development Corporaton, 2014
Rapid Dump Valve 4111-2
Dimensions (Inches)
Rev. 10/14 02