Norgren Gauges - Manual (Page 4)

N/en 8.900.900.04
18-013-..., V70534-..., 9273...
Our policy is one of continued research and development. We therefore reserve the right to amend,
without notice, the specifications given in this document. © 2014 Norgren Americas
2000-8192c
7/14
Center back connection, panel mounted, black face
(for North America)
Center back connection, panel mounted, black face
(for North America)
Symbol Scale range
psig *1) bar Mpa
Model - Diameter & Connection
Ш 1.5” (Ш 40 mm)
1/8 NPT außen & 10 ... 32 innen
0 ... 30 0 ... 2 0 ... 0.2 5PG-306-000
0 ... 60 0 ... 4 0 ... 0.4 5PG-312-000
0 ... 100 0 ... 7 0 ... 0.7 5PG-320-000
*1) primary scale
Symbol Scale range
psig *1) bar Mpa
Model
Ш 1.5” (Ш 40 mm)
Ø 5/32” PIF (Ø 4 mm)
0 ... 100 0 ... 7 0 ... 0.7 18-013-538
*1) primary scale
ø J ø K ø L
C
P
G M
B
A
Ø A B C G Ø J Ø K
1.5 (40) 1/8 NPT 1.69 (43) 0.60 (15) 1.61 (41) 1.63 (41)
Ø L M P Weight (lb)
2.1 (53) 0.18 (4,5) 1.04 (27) 0.55 (14) 0.15 (68 g)
Ø A Ø B C Ø J Ø K
1,5 (40) 0.156 (4) 1.71 (43) 1.61 (41) 1.63 (41)
Ø L M P Weight (lb)
2.1 (53) 0.18 (5) 0.86 (22) 0.55 (14) 0.15 (68 g)
Dimensions in inches (mm) Dimensions in inches (mm)
ø J ø K ø L
C
P
M
B
A
Projection/Third angle Projection/Third angle
Warning
These products are intended for use in industrial compressed air and
fluid systems only. Do not use these products where values can
exceed those listed under »Technical features/data«.
Before using these products with other than those specified, for non-
industrial applications, life-support systems, or other applications
not within published specifications, consult NORGREN.
Through misuse, age, or malfunction, components used in
fluid power systems can fail in various modes.
The system designer is warned to consider the failure modes of all
component parts used in fluid power systems and to provide adequate
safeguards to prevent personal injury or damage to equipment in the
event of such failure.
System designers must provide a warning to end users in the system
instructional manual if protection against a failure mode cannot be
adequately provided.
System designers and end users are cautioned to review specific
warnings found in instruction sheets packed and shipped with
these products.