Revolabs FLX2 Advanced - Manual (Page 9)

Configuring the system
Before using the conference phone for the first time, the
FLX2 will walk you through some configuration setup.
First, it will ask for the language to use. The six options
are English, Español (Spanish), Français (French),
Deutsch (German), Italiano (Italian), and Português
(Portuguese). Highlight the language of your choice,
and press either “Enter” or “Select” on the Dialer to
select it. Once a language is select, the system will use
that language for all screen contents. Please ensure
that you selected the right one. If the wrong language
was selected, it can be changed in the advanced setup
menu of the dialer, however you will have to navigate
through screen content in the selected language to get
there.
Once the language is selected, the system will ask for
the region or country in which the system is used. This
setting is required to configure the telephone interface of
the FLX for the requirements of that country or region. If
your country or region is not in the list, please contact
Revolabs support.
Lastly, the system will ask for date and time settings.
Please enter the current time and date.
Language, country / region, and time settings can be
changed in the menu on the dialer. The corresponding
menus are described later on in this document.
Making a call
To make a conference call, take at least one of the
Microphones out of the Charger Base, and take the Dialer out of the Charger Base.
You can remove all Microphones and the Speaker if you wish, but this is not required.
Use the Dialer to enter the number you want to call, including any leading digits your
telephone connection might require. The Speaker and any Microphone that is not in the
Charger Base will be active during the call. To finish a conference call, press the red
hang-up button on the Dialer.
NOTE: It is also possible to have a conference call with the
microphones in the charger base. However, due to the proximity
of microphone and speaker at that time, audio quality might be
impacted. The maximum volume of the speaker is limited while
the microphones are in the charger base. Microphones that are
placed into the charger base are switched off. To use
microphones in the charger base for phone calls they first have
to be switched on. You do this by pressing the button on the