Revolabs Single Channel Wireless Microphone System - Tandberg 880 MXP - Manual

Revolabs Single Channel Wireless Microphone System- Tandberg 880 MXP
Setup Guide
N OTES AND C AUTIONS :
This setup guide will guide you through the steps needed to properly connect a
Revolabs Single Channel System to a Tandberg 880 MXP video codec.
1. Connecting the Cables
2. Configuring the 880 MXP Video Codec
Note: It is important to carefully follow these instructions in order and completely.
Otherwise your Single Channel System and/or the video codec may not function
properly. Please read through these instructions completely before proceeding.
Contact Revolabs technical support if you have any questions.
Requirements for connecting systems:
1. Revolabs Single Channel System
2. Tandberg 880 MXP video codec
3. QTY 1 07-STEMIC-PPP Line-to-Mic Interface Cable*
*
OPTIONAL FROM
R
EVOLABS
NOTE:
IMAGES OF SET UP SCREENS ARE DEFAULT SETTINGS FROM
T
ANDBERG AND ARE PART OF THE
T ANDBERG MXP A DMINISTRATOR ’ S G UIDE © M AY 2008