Kodak Z5010 - Manual (Page 52)

44 www.kodak.com/go/support
Troubleshooting
Flash does not fire ■ Check the flash setting, and change as needed ( see page 11 ).
NOTE: The flash does not fire in all modes.
Memory card is almost
or entirely full ■ Transfer the pictures to the computer ( see page 40 ).
■ Delete pictures from the card ( see page 23 ) or insert a new card.
The Reset Camera
feature did not take
effect. ■ After using the Reset Camera feature ( see page 38 ), turn the
camera off and then on again.
Battery life is short ■ Make sure the correct battery type is installed ( see page 52 ).
■ Charge the batteries ( see page 1 ). Watch the battery level ( see
page 8 ).
■ Use a power-saving LCD Brightness setting ( see page 37 ).
■ Limit on-camera reviewing, which consumes power.
Shutter button does
not work. ■ Turn on the camera ( see page 3 ).
■ Transfer pictures to the computer ( see page 40 ), delete pictures
from the camera ( see page 23 ), or insert a card with available
memory ( see page 4 ).
Memory card not
recognized or camera
freezes with card ■ Card may be corrupted. Format the card in the camera ( see
page 39 ).
Caution: Formatting a card deletes all pictures and
videos.
■ Use another memory card. Only SD or SDHC Cards are supported.
Pictures on card (or in
internal memory) are
corrupted ■ Retake pictures.
■ Do not remove card while the camera is on.
■ Keep rechargeable batteries charged.
■ Transfer pictures to the computer ( see page 40 ), then format the
card or internal memory ( see page 39 ).
Caution: Formatting a card deletes all pictures and
videos.
Status Solution