Lenovo ThinkServer TD100x - Manual (Page 65)

4. Touch the static-protective package containing the ServeRAID 8k-l adapter to
any unpainted metal surface on the server. Then, remove the ServeRAID 8k-l
adapter from the package.
5. Turn the ServeRAID 8k-l adapter 2 so that the ServeRAID 8k-l adapter keys
align correctly with the connector.
Attention: Incomplete insertion might cause damage to the system board or
the ServeRAID 8k-l adapter.
6. Press the ServeRAID 8k-l adapter firmly into the connector.
7. If you have other options to install or remove, do so now.
8. Replace the side cover (see “Reinstalling the side cover” on page 57). Go to
“Completing the installation” on page 55.
Installing the ServeRAID-8k adapter (TD100x models)
The optional ServeRAID-8k adapter can be installed only in its dedicated connector
on the system board. See the following illustration for the location of the connector
on the system board. The ServeRAID-8k adapter is not cabled to the system board,
and no rerouting of the SAS or SATA cable is required on many models. However, if
you install this optional ServeRAID-8k adapter in simple-swap SATA models, some
recabling is required.
To install the ServeRAID-8k adapter, complete the following steps.
1. Read the safety information that begins on page v and “Handling
static-sensitive devices” on page 22.
2. Turn off the server and peripheral devices, and disconnect the power cords
and all external cables.
Attention: To avoid breaking the retaining clips or damaging the
ServeRAID-8k adapter connector, open and close the clips gently.
3. Remove the side cover (see “Removing the side cover” on page 25.
4. Open the retaining clips on each end of the ServeRAID-8k adapter connector.
5. Touch the static-protective package that contains the ServeRAID-8k adapter to
any unpainted metal surface on the server. Then, remove the ServeRAID-8k
adapter and battery pack from the package.
Chapter 2. Installing optional devices 51