Lenovo THINKPAD Z60M - Manual (Page 121)

Table 34. Computer Configuration>Rescue and Recovery>Settings (continued)
Policy Setting Sub-Setting Description
Backup Backup
Network
Enable or disable ’Backup
Network’ as selected
destination for backup.
Default: Disabled.
Notes:
1. If a service partition
backup fails due to
insufficient space,
manually delete partial
backups before
attempting another
backup or restoring
from the failed backup.
2. When backing up the
service partition to
external media, set the
following registry key
before restoring your
system with Rescue and
Recovery:
HKLM\Software\Lenovo\
Rescue and Recovery\
Settings\Backup\
BackupSPNetwork=1
Backup Local Partition
Number
Set the partition number for
backups on the local drive.
Valid values: 1-100. Default:
1.
Backup USB Partition
Number
Set the partition number for
backups on the USB drive.
Valid values: 1-100. Default:
1.
Backup Second HDD
Partition
Number
Set the partition number for
backups on the Second
hard disk drive. Valid
values: 1-100. Default: 1.
Backup Backup
Partitions
Select the partitions that
should be backed up. This
DWORD is a bitmap of
logical drive letters that
should be included in the
backup. Example: To only
backup drive c: and e:, this
value should be
0x00000014. Note: Convert
your hexadecimal number
to decimal before entering.
Default: 0xFFFFFFFF.
Entering a zero has a
meaning similar to the
default: Find all available
partitions and back them
up.
Appendix A. Command-line tools 115