Lenovo THINKPAD Z60M - Manual (Page 85)

Table 28. Antidote Delivery Manager commands (continued)
Commands Description
RETRYONERROR [ON|OFF] retries By default, a script will only be tried once. However,
if it is important to keep trying a script until it works,
the RETRYONERROR command can be used to
notify the mailbox function to keep trying to execute
this script a finite number of times as specified by the
retries parameter. If no number is specified, the
default value is 3.
MSGBOX /msg message text [/head header_text] [/OK]
[/CANCEL]| [/TIMER timeout]
The MSGBOX command will display a message to
the end user, if logged on. The message will remain
displayed and the script will block until time out
occurs, the cancel button is pressed or the OK button
is pushed (if /OK is specified). A cancel button will
not be on the panel if /CANCEL is not specified, and
it will not be easy to get rid of the display. The
command will return:
v 0 = OK was pressed
v 1 = CANCEL
v 2 = Timer expired
The text in the message can be formatted using \n
and \t to represent newline and tab respectively.
NETWK [/D|/E|/A [/IP ip_address | /DN domain_name]
[/NM netmask]
NETWK /D (disable) will stop all network traffic by
disabling all network adapters. Networking will be
disabled until a NETWK /E (enable) command is
run. NETWK /A restricts networking to the IP
address specified by either the /IP switch (dotted
decimal) or /DN (DNS name). The /NM switch
provides the network mask. If /NM is not provided,
then only the single machine specified by /IP or /DN
will be accessible. The state of this command persists
over reboots, so networking must be explicitly
enabled.
APUBKEY [/ADD|/DEL] asn_1_encoded_public_key The APASSWD command allows an administrator to
remotely manage the Antidote Delivery Manager
message signing keys on each PC. More than one key
can be stored on each PC. If a signed message is
processed, each key will be tried until a successful
one is found. Keys are not separately named, so must
be referenced by the content. A new key can be
added using the ADD parameter and deleted with
the DEL parameter.
AUNCPW [/ADD|/CHANGE|/DEL] unc [/USER userid]
[/PWD password] [/REF ref_name]
This command allows you to add, change or delete a
password for a network drive The reference name
can be used as a shortcut in a message instead of
using the UNC. Return values are:
v 0 = Successful.
v 1 = Unable to set with the information provided.
v 2 = Successful, but a different UNC which has the
same reference name has already been defined.
Chapter 5. Antidote Delivery Manager infrastructure 79