Lenovo ThinkServer TS430 User Manual

Page 120

Advertising
background image

What to do next:

• To work with another piece of hardware, go to the appropriate section.

• To complete the removal procedure, go to “Completing the parts replacement” on page 170. Because the

hardware RAID 5 and 50 levels are not available without the TR 500 key, you might need to reconfigure
RAID for your server. For information about how to configure the hardware RAID, refer to the MegaRAID
SAS Software User Guide on the documentation DVD that comes with your server.

For the ThinkServer RAID 700 Adapter: Installing or removing the
ThinkServer RAID 700 Battery

This topic provides instructions on how to install or remove the ThinkServer RAID 700 Battery (hereinafter
referred to as the TR 700 Battery) if your server has a ThinkServer RAID 700 Adapter installed.

The TR 700 Battery protects the integrity of the cached data on the ThinkServer RAID 700 Adapter by
providing backup power up to 72 hours in the case of a complete ac power failure or a brief power outage.
It has built-in functionality to automatically charge the battery pack and to communicate battery status
information (such as voltage, temperature, and current) to your server. It also provides an inexpensive
alternative to using an uninterruptible power supply, and a second level of fault tolerance when used in
conjunction with an uninterruptible power supply.

The temperature of the TR 700 Battery is generally 15-20°C (59-68°F) higher than the ambient temperature
during fast charge. Therefore, to complete a recharge cycle, the ambient temperature should be lower
than 55°C (131°F). If the ambient temperature exceeds 55°C (131°F), the recharge cycle will terminate
prematurely, thus preventing the TR 700 Battery from reaching a fully charged state. A recharge cycle lasts
at least six hours under normal operating conditions.

Attention: It is recommended that you replace the TR 700 Battery annually or after 500 recharging cycles,
whichever comes first.

Installing the TR 700 Battery

Attention: Do not open your server or attempt any repair before reading and understanding the “Safety information”
on page iii
and “Guidelines” on page 85.

This topic provides instructions about how to install the TR 700 Battery on a ThinkServer RAID 700 Adapter if
one is installed on your server.

Before you begin, print all the related instructions or ensure that you can view the PDF version on another
computer for reference.

Note: Use any documentation that comes with the TR 700 Battery and follow those instructions in addition
to the instructions in this topic.

To install the TR 700 Battery, do the following:

1. Remove all media from the drives and turn off all attached devices and the server. Then, disconnect all

power cords from electrical outlets and disconnect all cables that are connected to the server.

2. Remove the server cover. See “Removing the server cover” on page 87.

3. Lay the server on its side for easier operation.

4. If a PCI card bracket assembly is installed in your server, remove the PCI card bracket assembly. See

“Removing and reinstalling the PCI card bracket assembly” on page 91.

5. Locate the ThinkServer RAID 700 Adapter, which is located in the PCI-E slot 3 on the system board.

6. Remove the ThinkServer RAID 700 Adapter, which is a kind of RAID card. See “Installing or removing

the RAID card” on page 103.

108

ThinkServer TS430 User Guide

Advertising