Lenovo ThinkServer TS430 User Manual
Page 154
2. Remove the server cover. See “Removing the server cover” on page 87.
3. Remove the front bezel. See “Removing and reinstalling the front bezel” on page 89.
4. Locate the hot-swap hard-disk-drive backplanes. See “Hot-swap hard-disk-drive backplane” on page
5. Remove the front system fan. See “Replacing the front system fan” on page 157.
6. Remove all the installed hot-swap hard disk drives and dummy trays (if any) from the hard-disk-drive
cage. See “Installing or replacing a hot-swap hard disk drive” on page 127.
7. Record the cable connections on the backplane and then disconnect all the cables from the backplane.
8. Lift the release latch
1
and slide the hard-disk-drive cage out of the front of the chassis.
Note: The following illustration shows the 3.5-inch hard-disk-drive cage. For the 2.5-inch hard-disk-drive
cage, the removal procedure is the same.
Figure 79. Removing the hard-disk-drive cage
9. Depending on whether your server has a 2.5-inch hot-swap hard-disk-drive cage with backplane or
3.5-inch hot-swap hard-disk-drive cages with backplanes, do one of the following:
142
ThinkServer TS430 User Guide