Lenovo D400 Desktop IdeaCentre - Manual (Page 28)

23
Hardware Maintenance Manual
Serial ATA
Enables or disables the onboard SATA ports. The default is set to Enabled.
To enable the onboard SATA ports:
1. Start the Setup Utility program. See “Starting the Setup Utility program”.
2. From the Setup Utility program menu, select Advanced > Advanced Chipset
Control.
3. Select Serial ATA.
4. Select Enabled, then press Enter.
5. Return to the Setup Utility program menu and press F10 to save configuration
changes and exit setup.
Selecting a startup device
If the home center does not start up (boot) from the hard disk, use the
procedure below to startup the device.
Selecting or changing the startup device sequence
To view or permanently change the configured startup device sequence:
1. Start the Setup Utility program. See “Starting the Setup Utility program”.
2. From the Setup Utility program menu, select Boot.
3. Set the drive priority during system boot-up.
4. Return to the Setup Utility program menu and press F10 to save configuration
changes and exit setup.
Exiting from the Setup Utility program
When you finish viewing or changing settings, press Esc to return to the Setup
Utility program menu (you might have to press Esc several times). If you want to
save the new settings, select Exit Saving Changes before you exit. Otherwise,
your changes will not be saved.
Note
If you do not want to save the settings, select Exit Discarding Changes from
the Exit menu.