Replacing, Diskette, Drive – Lenovo THINKSTATION S10 User Manual

Page 42: Optional, Card, Reader, Removing

Advertising
background image

5.

Press

the

drive

latch

1

(for

the

drive

you

want

to

remove)

and

slide

the

optical-drive

from

the

chassis.

6.

Install

the

new

optical-drive

from

the

front

of

the

drive-bay

assembly.

Slide

the

optical-drive

toward

the

rear

of

the

chassis

to

lock

the

drive

into

position.

7.

Connect

the

flat

cable

to

the

new

optical-drive.

8.

Go

to

Chapter

4,

“Completing

the

parts

replacement,”

on

page

43.

Replacing

the

diskette

drive

or

optional

card

reader

Attention

Do

not

open

your

computer

or

attempt

any

repair

before

reading

the

“Important

safety

information”

in

the

Safety

and

Warranty

Guide

that

was

included

with

your

computer.

To

obtain

a

copy

of

the

Safety

and

Warranty

Guide,

go

to

the

Support

Web

site

at:

http://www.lenovo.com/support/

This

section

provides

instructions

on

how

to

replace

the

diskette

drive.

1.

Open

the

computer

cover.

See

“Opening

the

cover”

on

page

12.

2.

Remove

the

front

bezel.

See

“Removing

the

front

bezel”

on

page

14.

3.

Locate

the

drive

cable

connectors.

See

“Identifying

parts

on

the

system

board”

on

page

9.

4.

Note

the

location

of

the

drive

cables.

Disconnect

the

drive

cables

from

the

system

board.

Figure

21.

Removing

the

diskette

drive

or

optional

card

reader

drive

34

ThinkStation

Hardware

Installation

and

Replacement

Guide

Advertising