Chapter 4. completing the parts replacement, Updating (flashing) bios from a diskette or cd-rom, Chapter – Lenovo THINKSTATION S10 User Manual

Page 51: Completing, Parts, Replacement, Updating, Flashing), Bios, From

Advertising
background image

Chapter

4.

Completing

the

parts

replacement

After

replacing

the

parts,

close

the

cover

and

reconnect

cables,

including

telephone

lines

and

power

cords.

Also,

depending

on

the

part

that

was

replaced,

you

might

need

to

confirm

the

updated

information

in

the

Setup

Utility

program.

Refer

to

″Using

the

Setup

Utility

program

in

the

User

Guide

for

this

product.

To

complete

the

parts

replacement:

1.

Ensure

that

all

components

have

been

reassembled

correctly

and

that

no

tools

or

loose

screws

are

left

inside

your

computer.

See

“Locating

internal

components”

on

page

8,

for

the

location

of

various

components.

2.

Make

sure

that

the

cables

are

routed

correctly.

Important

Correctly

route

all

power

supply

cables

to

avoid

interference

with

the

drive

bay

assembly.

Keep

cables

clear

of

the

hinges

and

sides

of

the

computer

chassis.

3.

Close

the

computer

cover.

4.

If

a

cover

lock

is

installed,

lock

the

cover.

5.

Reconnect

the

external

cables

and

power

cords

to

the

computer.

See

“Locating

connectors

on

the

rear

of

your

computer”

on

page

6.

6.

If

you

are

replacing

the

system

board

or

microprocessor,

you

must

update

(flash)

the

BIOS.

See

“Updating

(flashing)

BIOS

from

a

diskette

or

CD-ROM.”

7.

To

update

your

configuration,

see

″Using

the

Setup

Utility

program

in

the

ThinkStation

User

Guide.

Note:

In

most

areas

of

the

world,

Lenovo

requires

the

return

of

the

defective

CRU.

Information

about

this

will

come

with

the

CRU

or

will

come

a

few

days

after

the

CRU

arrives.

Updating

(flashing)

BIOS

from

a

diskette

or

CD-ROM

Important

Start

the

Setup

Utility

program

to

view

your

system

information.

See

“Using

the

Setup

Utility

program”

in

the

User

Guide

for

this

product.

If

the

serial

number

and

the

machine

type/model

listed

on

the

Main

menu

do

not

match

what

is

printed

on

the

label

of

your

computer,

you

must

update

(flash)

the

BIOS

to

change

the

serial

number

and

the

machine

type/model.

To

update

(flash)

the

BIOS

from

a

diskette

or

CD-ROM,

do

the

following:

1.

Insert

a

system

program

update

(flash)

diskette

or

CD

into

the

diskette

drive

or

optical

drive.

System

program

updates

are

available

at:

http://www.lenovo.com/support/

Note:

If

you

are

inserting

a

CD-ROM

into

the

optical

drive,

make

sure

that

the

computer

is

turned

on.

©

Lenovo

2005,

2008.

Portions

©

IBM

Corp.

2005.

43

Advertising