Replacing the primary hard disk drive – Lenovo H520e Desktop User Manual

Page 91

Advertising
background image

1. Release the lever securing the microprocessor retainer and open the retainer to access the

microprocessor.

2. Grasp the microprocessor on the sides and lift it straight up and out of the socket. Do not touch the

contacts on the microprocessor socket.

3. Lower the microprocessor retainer, and then lower the lever to secure the retainer. Make sure the

lever is locked into position.

4. Note the orientation of the socket cover, and install one side of the socket cover into the microprocessor

socket.

Figure 26. Installing one side of the socket cover into the microprocessor socket

Note: Your microprocessor socket and cover might look slightly different from the illustration.

5. Carefully press the other side of the socket cover downward until the socket cover snaps into position.

6. Carefully check the four corners of the socket cover to make sure that the cover is secured in the

microprocessor socket.

7. Follow any additional instructions included with the replacement part you received.

Replacing the primary hard disk drive

Attention:

Do not open your computer or attempt any repair before reading and understanding the “Important safety information”
in the User Guide. To obtain a copy of the User Guide, go to:
http://www.lenovo.com/ThinkCentreUserGuides

This section provides instructions on how to replace the primary hard disk drive.

To replace the primary hard disk drive, do the following:

1. Turn off the computer and disconnect all power cords from electrical outlets.

2. Remove the computer cover. See “Removing the computer cover” on page 70.

3. Locate the primary hard disk drive. See “Locating internal drives” on page 67.

Note: There is also a secondary hard disk drive bay for you to purchase and install a secondary hard
disk drive by yourself. If you want to install a secondary hard disk drive, use the same way of installing
the primary hard disk drive.

4. Disconnect the signal cable and the power cable from the hard disk drive.

5. Remove the four screws that secure the hard disk drive. Then, slide the hard disk drive out of the chassis.

Chapter 9

.

Replacing FRUs

87

Advertising