Aiphone IS-SOFT - Manual (Page 26)

26
Monitoring
You can monitor a sub station or multiple sub stations in your
site sequentially (scan-monitoring) with a PC master station.
When monitoring a video door station, you can view the *
image at the station and hear the sound. When monitoring an
audio door station or room sub station, you can only hear the
sound at the station.
■ Monitoring
Search for and select the sub station in your site you 1
want to monitor (so that it is highlighted) in one of the
search methods. (→P. 21-24)
NOTE:
You cannot monitor a (PC) master station and remote site.
Click 2 (when "[ ] MONI" is displayed).
You can hear the sound and if the station has a camera,
you can also view the image.
* appears in the area for a status display icon.
Click 3 to fi nish monitoring.
NOTES:
If the selected station is being used (calling, communicating, being •
monitored, etc.), you cannot monitor the station.
If you click • while monitoring, the communication mode starts
with the station after a tone.
During video monitoring, you can switch Zoom/Wide, make Pan •
& Tilt control and adjust images on the monitor. (
→
P. 15-16)
To shift to scan-monitoring
Clic k duri ng monitoring.
If the station being monitored is a preset one for scan- *
monitoring, the scan-monitoring starts from the subsequent
station in the scan-monitoring order.
If the station being monitored is not a preset one for scan-
*
monitoring, the scan-monitoring starts from the fi rst station in
the scan-monitoring order.
■ Scan-monitoring
You can monitor the preset stations in your site (up to 20 door
stations and/or room sub stations) sequentially, each for the set
duration.
The stations should be preset in the System setting on a PC. *
Click 1 in the standby mode.
The stations set for scan-monitoring are monitored
sequentially, each for the set duration.
Click 2 to stop scan-monitoring.
* appears in the area for a status display icon during
scan-monitoring.
To monitor only the desired station continuously:
Click when the target station is being monitored during
scan-monitoring.
Click * again to restart the scan-monitoring.
NOTES:
Clicking • is invalid during scan-monitoring.
If the PC master station receives a call during scan-monitoring, the •
scan-monitoring ends automatically.
If one of the preset stations is being used (calling, communicating, •
being monitored, etc.) during the scan-monitoring, it will be
skipped.
During the scan-monitoring, the Zoom/Wide, Pan & Tilt, door •
release and image adjusting functions are disabled. (The camera is
fi xed in the Wide mode.)
Viewing video images at the target station
When you are receiving a call from, communicating with a
video door station, or monitoring a video door station in your
site, you can view video images at the target station.
Use the following functions on the PC master station to control
video images as you prefer. (→P. 15-16)
Switching Zoom/Wide •
Pan & Tilt •
Adjusting images •
NOTE:
Video images cannot be controlled during scan-monitoring.