Konica Minolta bizhub PRESS 2250P - Manual (Page 14)

Operator Manual STR0202 & SFM0704
DBCB-0512-0066-V005
STR0202 2-Side Trimmer & SFM0704 Square Fold Module
V005 RI01 23-04-2012 DBCB-0512-0066-V005 - 14 -
4. Operating the STR (continued)
4.5 Job Setup
Fig. 1 Fig. 2
Fig. 3 Fig. 4
Step Action Remarks
1. Job Setup Press the ‘Jobs’ button two times (Fig. 1& 2).
2A. Make a new Job Press the ‘New’ button (Fig. 3).
2A. Enter Job name Use the ‘ + / -‘ and ‘ ►’ buttons (Fig. 4) to Enter the Job
name and press the ‘Enter’ button.
A “Loading Job” message appears for a few
seconds.
2B. Adjust a Job Use the ‘
▲ / ▼ ’ buttons to select a Job and press the
‘Enter’ button to load or confirm.
A “Loading Job” message appears fora few
seconds.
3. Adjust Input Size and/or Side
Trim Use the ‘
▲ / ▼ ’ and the ‘+ / -‘ buttons to set the
desired settings for Input Size and Side Trim
(See Chapter:
4.6 Paper Input Size Setup
4.7 Side Trim ON/OFF )
4. Save Job After adjusting press ‘Jobs’ (Fig. 1) and save the current
Job or ‘Rename’ the adjusted Job by pressing the
‘Enter’ button (Fig. 2).
A “Saving Job” message appears for a few
seconds.
After Renaming a Job, repeat step 2A: ‘Enter
Job name’.